DemoEng

1.

Choose number
of Cylinders
Choose injector
type
Set up language
and COM

2.

Choose power
range
Choose LPG or
CNG
Choose reducer
type
Choose Level
sensor type

3.

Choose RPM for first
switching to gas, if
needed
Choose the switching
pressure 0,6 – 1BAR
under the working one

4.

Use nozzle
calculator

5.

Follow the
instructions for
AutoTuning

6.

If you have
massage without
“OK”, you can use
“Manual
adjustment”

7.

Read instructions

8.

Use this slider to
equal both petrol
times on petrol and
on gas

9.

mum gas time' - is designed to adjust the
s on gas, after them the system will open
injectors permanently, insuring enough
at high RPM and big power. This could be
uired for high power cars, over 200 PS or
me turbo cars /at 6000 rpm it musn’t be
over 28ms/
USE THESE SLIDERS
AFTER READING
THE MANUAL

10.

Switch separately each cylinder
on gas to check is it working
properly
Check the equality of petrol
times to ensure cylinder
sequence (at 6 and 8 cyl.)
Check the ignition sequence to
verify proper cutting of petrol
injectors.

11.

For cars over 150 PS
with automatic
transmission better use
flat curve of adjustment
If you use fast
injectors readjust
the curve with this
slope
At CNG sometimes use 3D map
adjustment to precise gas
feeding in some specific points

12.

To work with the map, you have to switch to
menu “MAP” and the check box “USE MAP”.
There is also a red point, which is dynamic,
signing the three parameters at the present
moment. The change of the cell of the map or
square of cells you can make by mouse marking
(with blue colour) and pushing “ENTER”.

13.

Menu “GAS system errors”
After the system is fully adjusted, all the
parameters could be tested in drive mode,
after that you can receive from this menu
some useful messages for unprecised
adjustments or wrong choises of nozzles,
pressures, times etc. parameters.

14.

OBD Errors”. Using this menu, you could
read, analize and clear all errors,
established on the time of installing,
adjusting and using the gas system any
time. There is an option to automatically
delete by asking certain groups and four
individual errors!

15.

16.

USE THESE SLIDERS
AFTER READING
THE MANUAL